Security Ranger III Guia do Utilizador descarregar pdf (Página 104)

Factory Reset/Clean Boot

This procedure resets the Trimble Ranger to "factory fresh" condition and removes all previously added software,

including any Badger Meter software applications.

Start the factory reset procedure with the handheld powered on.

1. Press and hold the green power key.

2. When the countdown timer starts, also press and

hold the RIGHT key on the keypad.

Result: A screen appears, warning that the Clean Boot

operation will clear the unit.

3. Use the up/down navigation arrows on the keypad

to select the Ok button on the screen. Then press

the ENTER key on the keypad only if you want to

completely clear the handheld.

NOT:N Tapping does not work on the Clean Boot

screen. Use the keypad.

Several screens display during the next several

seconds: "Scanning...Wait" screen, Windows

Embedded screen, Finalizing screen, blank screen,

and then the Windows Embedded screen again.

4. Tap the screen to start the reset process.

5. Align the touch screen by tapping the cross hairs. Continue to tap the cross hairs until the screen aligns.

6. At the Password screen, tap Skip.

7. Tap the Complete screen to nish the reset.

NOT:N After performing a factory reset, the handheld date and time need to be reset. Tap Windows Start> Settings>

Clocks & Alarms to set the correct time and date.

ORION® Automated Meter Reading System for Trimble® Ranger 3

Page 104 February 2013

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 123 124

Sem comentários

Security Ranger III Guia do Utilizador Página 104